Sound Field Program Parameter Editing; Changing Parameter Setting - Yamaha RX-Z1 Owner's Manual

You can enjoy good quality sound with the preset parameters. Although you do not have to change the initial settings, you can change some
of the parameters to better suit the input source or your listening room.
Adjustment should be made with the remote control.
Turn on the video monitor.
_Go to the RECEIVER control and left
panel press
button (labeled "OSD") repeatedly to select the full
display mode.
_Go to one of the DSP control and select a DSP
panels
program you want to adjust.
_=i_.4 r ,]illiii- iMi..UiH,._ i
+ 70_!,'_SPecL_c!e
EFCT !°R!H .... 8,:!B
P,!!'1!!°.PLY.°!3!,'_s
F'.RO0!"!S!ZE_. i. '...3
S.DEL!:tY ..... 23!,'_s
S,ROOH S!ZE* _i,8
* This display shows the third DSP control panel.
!
Tap 3 (_ or _ repeatedly) to open the
PARAMETER control panel.
Tap @ or _ to select the parameter.
/TN
Tap _ or _ to change the parameter value.
When you set the parameter to a value other than the factory-
set value, an asterisk mark (*) appears by the parameter name
on the video monitor.
_ Repeat steps 3 to 6 above as to change
necessary
other parameters.
• The available parameters may be displayed on more than one
OSD page for some of the programs. To scroll through pages,
tap _ or @.
• You cannot change parameter values when "16 MEMORY
GUARD" on the SET MENU is set to "ON". If you want to
change the parameter values, set "16 MEMORY GUARD" to
"OFF" (see page __).
• To reset some of the parameters to the
factory-set values
/%
Select the parameter you want to reset. Then tap and hold _ or
until the value temporarily stops at the factory-set value. The
asterisk mark (*) by the parameter name disappears on the video
monitor.
• To reset all of the parameters to the factory-
set values
Use "10 PARAMETER INI" on the SET MENU to reset all of the
parameter values of all DSP programs within the selected group to
the factory-set values (see page __). This operation resets all of the
parameter values of all DSP programs within that group to the
factory-set values.
ii;!!;_i!iii!i_i_i!
,i0
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
E-105