Table of Contents
Advertisement
I-'!::1 _ vj [o_
[_o]_hjl;Io]lq
A macro
allows you to send a sequence
of IR commands
using a single button.
When you select "MACRO"
in the Macro menu,
seven macro
groups
("DVD",
"GAME",
etc.) appears
by default.
Each group includes
buttons
that allow you to record a sequence
of commands.
In the Macro
menu,
there are two other macro groups
("POWER"
and "SOURCE").
• POWER
When you select "POWER"
in the Macro menu,
you see the touch
screen that appears
when you tap _
in the Home menu panel. Com-
mands
for turning
several AfV components
on or off at the same time are recorded
in each power group
button.
A command
for turning
a
single component
on or off is recorded
in the corresponding
component
button.
• SOURCE
_
,_
When you select "SOURCE"
in the Macro
menu, you see the touch screen that appears
when tapping
_
or _
in the Home menu panel.
A command
to switch
the component
control
panel (and to switch the input of this unit, not of all components)
is recorded
in each compo-
nent button.
You can enhance
and customize
macros
by recording
new commands
and editing
them.
• To record
a macro,
there must be at least one macro group
in the Macro
menu. To create these groups,
see "Organizing
macros
into groups"
on page.
• Brands
must be defined
before macro can be set.
•
Recording
macros
_
Tap_.
_Open
the Macro
menu and select
a macro
group.
•
Adding
a component
to a power group
Select "POWER"
on the Macro
menu in step 2 and tap the button
that corresponds
to the component
to which you want to assign the
power
on/off command
in step 4. Then tap the power
on/off button
in the component
control panel in step 5.
_
witch to the Edit mode via _;
at the bottom of the
touch screen.
Empty macro buttons appear in the macro control panel.
_Tap
the button
want to use for
macro.
you
your
TEnter
the
of commands
want to record.
sequence
you
You can navigate to any control panel you want, just as you do
in Use mode.
• Use _
or _
when switching to another page within the
same component. Do not tap the item tab that corresponds to
each command group (as you do with the "DSP", "INPUT"
tab, etc., that appear in the RECEIVER control panels).
_
Tap _.
The contents of the macro appear. You can now play, edit or
close the macro.
_
ress the left button to close the macro.
A confirmation screen appears that enables you to save or
cancel the macro.
Tap
The macro is ready for use.
E-85
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
