Speaker Mode Settings; Summary Of Speaker Set Items; Mode Setting - Yamaha RX-Z1 Owner's Manual

This unit has seven SPEAKER SET items in the SET MENU that you must set according to the number of speakers in your configuration
and their size. The following table summarizes these SPEAKER SET items, and shows the initial settings as well as other possible settings. If
the initial settings are not appropriate for your speaker configuration, change the settings in the SET MENU.
• Summary of SPEAKER SET items 1A through 1G
Control value (default
Item Description setting indicated in bold)
1A CENTER SP Selects the output mode according to whether or not a center speaker is being used and its LRG/SML/NONE
performance.
1 B MAIN SP Selects the output mode according to the performance of the main speakers. LARGE/SMALL
1C REAR L/R SP Selects the output mode according to whether or not rear L/R speakers are being used and LRG/SML/NONE
their performance.
1 D REAR CT SP Selects the output mode according to whether or not a rear center speaker is being used and its LRG/SML/NONE
performance.
1 E LFE/BASS OUT Selects the speaker according to use for LFE signal output and low bass signal. SW/MAIN/BOTH
1 F FRONT EFCT SP Selects the output mode according to whether or not front effect speakers are being used. YES/NONE
1G MAIN LEVEL
Selects the main speaker level.
Normal/-10dB
• When you select 6CH INPUT as the input source, settings of "1 SPEAKER SET" on the SET MENU do not apply (except for "IG MAIN
LEVEL").
• When the digital signals with over 96 kHz sampling frequency are input, only the "IG MAIN LEVEL" setting is effective.
• Mode setting
Adjustment should be made with the remote control.
_Tap _ on the Home menu to open the RECEIVER
control panels.
Tap q (_ or _ repeatedly) to open the
...... SET MENU control panel (page 7/8).
Select "1 SPEAKER SET" on the SET MENU.
Tap @ or _ to display the SET MENU on the video
monitor. Tap @ or _ repeatedly to select "1 SPEAKER
SET" on the SET MENU.
Enter the setting mode.
F_
Tap _ or _ to enter the setting mode. The current setting is
shown on the front panel display and the video monitor. Select
item (IA - IG) to be set by tapping @ or _.
_ Change the setting.
/y_
Tap _
or _ to change the setting for the selected item.
_ Close the SET MENU.
Tap _ or _ repeatedly until the DSP program name
appears to close SET MENU or tap and select one of
the DSP program.
3,4,6
4,5
E-34