Optional Output Connection; Ethernet Connection - Extron electronics ISM 482 User Manual

Optional output connection

DVI output connector (optional) — If the optional DVI output
6
card is installed, connect a DVI/DFP-compatible video display to
this DVI connector. This connector outputs the image selected for
output 1 only.
For output resolutions with less than 1024 pixels horizontally, the
optional DVI output's true horizontal resolution is limited to 1024
pixels. For the 1365 x 1024, 1080p, and 1080i output resolutions,
the optional DVI output's true horizontal resolution is limited to
1280 pixels. The DVI card outputs all other selected resolutions
normally. See the table on page 3-10.

Ethernet connection

Ethernet port — If desired, connect the switcher to an Ethernet LAN or WAN
7
via this RJ-45 connector. Ethernet control allows the operator to control the
switcher from a remote location. When connected to an Ethernet LAN or
WAN, the switcher can be accessed and operated from a computer running a
standard Internet browser.
Ethernet connection indicators — The Link and Act LEDs indicate the status
of the Ethernet connection.
The Link LED indicates that the switcher is properly connected to an Ethernet
LAN. This LED should light steadily.
The Act LED indicates transmission of data packets on the RJ-45 connector.
This LED should flicker as the switcher communicates.
Integration Scaling Matrix Switcher • Installation 2-7