Picture Adjustments - Extron electronics ISM 482 User Manual

Operation, cont'd

Picture adjustments

The picture adjustments allow you to fine tune the image quality of the selected
input. When you press one of the Picture Adjustments buttons (Color/Tint,
Brightness/Contrast, Size, Center, or Filter) once, the corresponding image
adjustment menu for the selected output (lit Output LED) image appears on the
LCD screen. Select the other output using the Output buttons to call the image
adjustment menu for the other output. In either screen, adjustments can then be
made by rotating the Adjust
settings are stored in nonvolatile memory; when the switcher is powered down and
powered up, the settings are restored.
Adjust an image for centering, sizing, brightness, contrast, color, tint, zoom, or
detail as follows (figure 3-13):
COLOR/
TINT
Output #1
Color Tint
127 128
NOTE Press the appropriate output button
to select the desired output.
Figure 3-13 — Picture adjustments flowchart
1.
2.
3-16 Integration Scaling Matrix Switcher • Operation
knob or the Adjust
Extron Electronics
Power
on
BRT/ SIZE
CONT
Output #1 Output #1
Brightness Contrast Horz Size
063 063 450
Press the desired input button and output button to select an input-output tie
to adjust.
The adjustments are made to the input signal as it is switched to the tied
output (1 or 2) only. (The output LED is lit and the selected output is shown
in the LCD). The adjustments do not affect the same input tied to the other
output.
Color adjustments are available only for component video, S-video, and
composite video inputs.
Tint adjustments are available only for S-video and composite video inputs.
Press the appropriate picture adjustment button: color and tint, brightness
and contrast (Brt/Cont), sizing (Size), centering (Center), or filter. The LCD
display shows the name of the adjustment and the current setting value.
knob. Picture adjustment
Extron Electronics
ISM 482 ISM 482
Integration 60-425-01
Scaling Matrix Version xxxx
2 sec.
CENTER
Output #1
Vert Horz Center Vert
400 500 550
NOTE The Adjust knob and the Adjust knob
are used to adjust the image settings on the
left and right sides of the LCD screen,
respectively.
Display
2 sec.
Cycle
FILTER
Output #1
Horz Filter Vert
3 7
10 sec.
timeout