Changing The System Boot Sequence - Intergraph TD-x10 Setup Manual

Reboot the system by turning the power off.
Do not use ctrl-alt-del for rebooting.
8. Remove the diskette from the floppy disk drive; then power off and restart the system.
9. When the following message displays, press
Hit DEL if you want to run Setup
10. In the Default menu of AMIBIOS Setup, click the Optimal icon. Select Yes to load the
values.
11. In the Setup menu, click the Advanced icon. Ensure that the Installed Memory Speed
parameter is matches the speed of your memory SIMMs.
12. If you customized the BIOS for your system, change the necessary parameters to their
previous values.
13. Select Exit and Save to exit AMIBIOS Setup.
14. Restart the system.

Changing the System Boot Sequence

To change the system boot sequence:
1. Restart the system.
2. Press
DELETE
Press DEL if you want to run Setup
3. The AMIBIOS Setup Main Menu displays.
4. In the Setup menu, click the Advanced icon. A list of parameters displays.
5. Click the System Boot Up Sequence parameter. The Options menu displays, with a
choice of boot sequences. The default is C:, A:, which designates the system hard disk
drive (C:) as the initial boot device, followed by the floppy disk drive (A:).
6. Click on the A:, C: parameter to reverse the boot sequence; then press
7. Select Exit and Save to exit AMIBIOS Setup.
8. Restart the system.
Until the boot sequence is changed back to C:, A:, the system will check for a bootable
diskette in the floppy disk drive before attempting to boot from the system's hard disk drive.
when the following message displays:
:
DELETE
47
.
ENTER