Changing The System Boot Sequence - Intergraph TD-x20 Setup Manual

11. In the Setup menu, click the Chipset icon. Ensure that the Installed Memory Speed
parameter is set to 60 ns.
12. If you customized the BIOS for your system, change the necessary parameters to their
previous values.
13. Select Exit and Save to exit AMIBIOS Setup.
14. Restart the system.

Changing the System Boot Sequence

To change the system boot sequence:
1. Restart the system.
2. Press
Press DEL if you want to run Setup
3. The AMIBIOS Setup Main Menu displays.
4. In the Setup menu, click the Advanced icon. A list of parameters displays.
5. Click the System Boot Up Sequence parameter. The Options menu displays, with a
choice of boot sequences. The default is C:, A:, CDROM, which designates the system
hard disk drive (C:) as the initial boot device, followed by the floppy disk drive (A:) and
the CD-ROM drive.
6. Click on the A:, C:, CDROM parameter to reverse the boot sequence; then press
7. Select Exit and Save to exit AMIBIOS Setup.
8. Restart the system.
Until the boot sequence is changed back to C:, A:, CDROM, the system will check for a
bootable diskette in the floppy disk drive before attempting to boot from the system's hard
disk drive.
when the following message displays:
DELETE
39
.
ENTER