Install Windows Nt Workstation 4.0 - Intergraph TD-x10 Setup Manual

Install Windows NT Workstation 4.0

Depending on your system's configuration, you will need some or all of the following system
software (on backup diskette or on the operating system CD-ROM) during installation:
u
SCSI adapter driver
u
Video display driver
u
Network adapter driver
u
Sound processor driver
u
QFE update software
u
RAID device driver (on a system with a RAID disk array)
Follow the instructions in Start Here to install Windows NT Workstation 4.0. As you install
the operating system:
u
When prompted to select a Setup type, select Custom Setup.
u
Skip automatic detection of mass storage devices during Setup.
u
Allow Setup to configure the network only if you have an installed network adapter, and
the system is connected to the network.
u
When prompted to create an Emergency Repair Disk, do so.
After installing the operating system:
u
Install drivers or other system software from any backup diskettes. System software on
backup diskette is usually more current than system software on the CD-ROM.
u
If you created a Quick-Fix Engineering (QFE) backup diskette during system
configuration, install the QFE update software. Refer to the
diskette for more information.
u
Complete additional installation tasks, described later in this chapter, as necessary.
u
Configure the system as described in Chapter 3, "Configuring the System."
u
Perform any additional installation and configuration tasks described in the Late-Breaking
News document delivered with your system.
u
Install additional accessories for the sound processor, available from the Intergraph
Bulletin Board Service (IBBS) or from vendor bulletin boards pointed to by the IBBS.
The system's hard disk drive contains Windows NT Workstation Setup files in the
directory. When installing network or video display adapter drivers, you can refer to the
directory when prompted for the location of Windows NT Workstation Setup files. If you
. file on the QFE
README TXT
:\ 386
C I
I
59
386