Table of Contents
Advertisement
ECP DMA Channel
This parameter activates when the Parallel Port Mode is set to ECP. You can select a DMA
channel for the parallel port when operating in ECP mode. Values for this parameter are
None, and CH 1 through CH 7. When the Parallel Port Mode is set to ECP, the default DMA
channel is 5.
Utility Menu
If an IDE controller is installed, use the following utilities to automatically detect and
configure any IDE drives you connect to the system. For information on setting an IDE
device to master or slave, refer to the documentation accompanying the device.
Detect Master
This parameter searches for the master IDE device. Any IDE drive found is then made
available for you to configure.
Detect Slave
This parameter searches for the slave IDE device. Any IDE drive found is then made
available for you to configure.
Security Menu
The Security Menu allows you to change the system password and enable or disable virus
protection.
Password
To prevent unauthorized users from accessing the AMIBIOS Setup program, enter a password
using this option. If you do not enter a password, the system does not prompt users for a
password when they start AMIBIOS Setup. This password does not affect the system logon
password.
NOTE
The Advanced Setup menu contains the Password Checking parameter that enables the
system to use the password that you enter.
To enter a password:
1.
Select the Password icon. The Password menu displays.
2.
Key in the characters (maximum of six) for the password.
3.
Key in the password to confirm it.
43
Advertisement
Table of Contents
Need help?
Do you have a question about the TD-x10 and is the answer not in the manual?