Peripheral Setup - Intergraph TD-x10 Setup Manual

41
DMA Channel x Usage
These parameters specify whether a given DMA channel is to be reserved for an ISA card, or
is free to be assigned to another device by the PnP BIOS. The options are PnP (default) and
ISA.
IRQ x Usage
These parameters specify whether a given IRQ is to be reserved for an ISA card, or is free to
be assigned to another device by the PnP BIOS. The options are PCI/PnP (default) and ISA.
ISA Reserved Memory Size
Use this parameter in conjunction with the ISA Reserved Memory Address parameter to
allocate a fixed amount of memory for ISA cards that require a specific amount of memory
and a set memory location. The memory size you select limits the memory addresses available
to assign to ISA cards.
ISA Reserved Memory Address
Use this parameter in conjunction with the ISA Reserved Memory Size parameter to allocate a
fixed amount of memory for ISA cards that require a specific amount of memory and a set
memory location. The memory addresses available depend on the memory size you select.

Peripheral Setup

The Peripheral Setup menu has parameters that affect option boards, serial ports, and parallel
port functionality.
Programming Mode
This parameter detects all installed option boards and configures the on-board components
accordingly. When set to Auto (the default), the system BIOS automatically detects the
installed option boards during boot up. When set to Manual, the next four parameters, plus
Parallel Port IRQ, activate.
OnBoard FDC
When set to Enabled (the default), this parameter enables the system floppy disk drive I/O
controller on the system board. If you install floppy controller cards, then this parameter must
be set to Disabled.