Using Amibios Setup; Standard Setup - Intergraph TD-x10 Setup Manual

Using AMIBIOS Setup

The AMIBIOS Setup menu allows you to change most of the BIOS settings. This section
describes the parameters grouped in the AMIBIOS Setup menu.

Standard Setup

The Standard Setup menu allows you to set the system date and time, and define floppy disk
drive parameters.
Date/Time
Select the Date/Time icon to display the current system date and time values.
To change the system date and time:
1. Click on the incorrect value with the mouse pointer or press the
highlights.
2. Click on the + or - buttons to change the value, or enter the correct value from the
keyboard.
NOTE The time displays in 24-hour format.
3. Press
ESC
Floppy A, Floppy B
The Floppy A and Floppy B icons allow you to specify the type of floppy disk drive installed
in the system.
The floppy disk drive A parameter is preset to 1.44 MB 3.5-inch. Do not change the
parameter unless you replace floppy drive A with a different capacity disk drive.
The floppy disk drive B parameter is preset to Not Installed, unless an optional drive has been
installed before shipment. Do not change the parameter unless you install an optional floppy
disk drive.
To change the floppy drive parameters:
1. Select the Floppy A or Floppy B icon.
2. Press the up and down arrow keys or click in a box to select the correct parameter for the
floppy disk drive.
3. Press
ENTER
floppy disk drive configuration menu.
to save the new values and return to Standard Setup.
to accept the change, or click on the close icon in the upper left corner of the
35
key until the value
TAB