Intergraph TD-x10 Setup Manual page 65

ERROR - Series of beeps and error message displays.
Message
1 - Refresh Failure
2 - Parity Error
3 - Base 64 KB Memory Error
4 - Timer Not Operational
5 - Processor Error
6 - 8042 - Gate A20 Failure
7 - Processor Exception Interrupt
8 - Display Memory Read/Write
Error
9 - ROM Checksum Error
10 - CMOS Shutdown Register
Read/Write Error
11 - Cache Error/External Cache
Bad
Explanation and Solution
Bad memory refresh circuitry on the system
board. Remove and re-install the SIMMs.
If error continues, replace the SIMMs.
Parity error in the first 64 KB block of
memory. Remove and re-install the SIMMs.
If error continues, replace the SIMMs.
Memory failure in the first 64 KB. Remove
and re-install the SIMMs. If error continues,
replace the SIMMs.
Memory failure in the first 64 KB, or Timer
1 on the system board is not functioning.
Call the Customer Response Center.
The CPU on the system board generated an
error. Call the Customer Response Center.
The BIOS cannot switch to protected mode.
Call the Customer Response Center.
The CPU generated an exception interrupt.
Call the Customer Response Center.
The sound controller is faulty. Call the
Customer Response Center.
The ROM checksum value does not match
the value encoded in the BIOS. Call the
Customer Response Center.
The shutdown register for CMOS RAM
failed. Call the Customer Response Center.
The external cache is faulty. Call the
Customer Response Center.
53