Table of Contents
Advertisement
26
2.
Select the appropriate monitor from the Monitor List. If your system's monitor is not
listed, select one with a maximum refresh rate matching the refresh rate your system uses.
An
MGA
NOTE
In a multiple G95 configuration, the MGA.INF setting affects all monitors. Intergraph
recommends that you select a monitor that is compatible with the least-capable monitor used
by your system.
To test the new monitor selection:
1.
Open Display in the Control Panel.
2.
Select the resolution and pixel depth you want to test.
3.
Select Test. If the display is satisfactory, go to step 6. If not, continue.
4.
If your monitor does not display a stable test screen, the parameters set by the
file are not suitable for your monitor. Select Cancel to close Display.
5.
Run MGA Monitor again to select a different monitor.
6.
Repeat steps 1 through 3 to test the video display with the new monitor selection. When
the display is satisfactory, close Display.
7.
Restart the system.
No resolution higher than the limit imposed by a monitor selection appears in the Display
mode list. Deleting the
refresh rate defaults to 60 Hz.
.
file will be created in the SystemRoot/
INF
.
file removes all monitor limits to the resolution, although the
MGA
INF
32 directory.
SYSTEM
.
MGA
INF
Advertisement
Table of Contents
Need help?
Do you have a question about the TD-x10 and is the answer not in the manual?