Creating An Emergency Repair Disk; Finding Customer Support; What Now; Creating An Emergency Repair Disk Or A Startup Diskette - Intergraph TD-x10 Setup Manual

22
If the system requires Quick-Fix Engineering (QFE) update software, it is included in the
system software available for backup diskette creation. QFE update software contains fixes
for operating system problems or limitations, and is only shipped with the system if it is
needed. If QFE update software is shipped with the system, you should create a QFE backup
diskette for use if you have to re-install the operating system.
Refer to Version Manager Help for information on creating Intergraph system software and
other diskettes. Check the Intergraph site on the World Wide Web and vendor bulletin boards
for new and updated drivers.

Creating an Emergency Repair Disk

If you did not create an Emergency Repair Disk during Setup, click the Repair Disk button on
the Repair Disk tab to create the appropriate diskette. The files on these diskettes can restore
the original contents of a damaged Registry (that is, at the time the operating system was
installed), along with the standard operating system drivers. You should also update an
Emergency Repair Disk after you finish configuring the system.
Refer to the operating system documentation and Help for information on creating an
Emergency Repair Disk.

Finding Customer Support

The Support tab contains information useful in contacting Customer Support. This
information is repeated in the Preface, earlier in this Guide.

What Now?

Refer to Chapter 3, "Configuring the System," to configure the system for use.
Refer to the online System Introduction for information on system features and controls.