Changing The System Boot Sequence - Intergraph TD-300 Maintenance Manual

Changing the System Boot Sequence

To change the system boot sequence:
1. Restart the workstation. The American Megatrends banner screen
displays with the following message:
Press DEL if you want to run Setup
2. Press
DELETE
3. Click on the Advanced icon. A list of parameters displays.
4. Click on the System Boot Up Sequence parameter. The Options menu
displays with choice of boot sequences. The default is C:, A:, which
designates the system hard disk drive (C:) is the initial device,
followed by the floppy disk drive (A:).
5. Click on the A:, C: parameter to change the boot sequence; then press
.
ENTER
6. Select the Exit and Save option to exit the AMIBIOS Setup program.
7. Insert an MS-DOS-bootable diskette into the floppy disk drive; then
restart the system.
For more information about the AMIBIOS Setup program, refer to Chapter
6, "Using AMIBIOS Setup."
Chapter 4 - Maintaining the System
. The AMIBIOS Setup Main Menu displays.
63