HP XP20000/XP24000 Manual page 422

Table 76 Error Codes — Part Code 8510 (continued)
Part Error
Code Number
8510 55636
8510 57001
8510 59067
8510 59068
8510 59101
8510 59102
422 Remote Web Console for Storage System Messages and Error Codes
Error Message
The CLPR that has some
parity groups cannot be
deleted. Migrate all parity
groups in the CLPR to another
CLPR, and then delete the
CLPR.
The partition configuration
may contain some
inconsistent information.
To initialize partition
configuration, select the Yes
button.
To stop the operation, select
the No button.
The maximum number of
SSIDs that can be registered
will be registered except the
duplicate SSIDs.
Notice from Partition
Definition
The SSID(s) are associated
with the specified CU. All
SSIDs that are associated
with the CU are to be added
to this SLPR.
The SSID(s) are associated
with the specified CU. All
SSIDs that are associated
with the CU are to be deleted
from this SLPR.
Recommended Action
Migrate all parity groups in
the CLPR to another CLPR,
and then delete the CLPR.
If you clicked [Yes], perform
the operation after you set up
a SLPR name and other
changes. If you clicked [No],
restart the operation. If this
problem persists, contact the
system management.
Check the settings.
Notice from Partition
Definition:
Check the settings.
Any statements of the
following are displayed in
%s.
Installation of XP
Disk/Cache Partition is
required to create more
than four SLPRs or CLPRs.
Additional Cache Memory
is required for CLPR0 to
create a CLPR.
Maximum number of
SLPRs exists.
Maximum number of
CLPRs exists.
Check the settings.
Check the settings.
Severity Failure
Level Level
W 0
E 3
W 0
i 0
i 0
i 0