HP XP20000/XP24000 Manual page 316

Table 54 Error Codes — Part Code 6505 (continued)
Part Error
Code Number
6505 68863
6505 68870
6505 68885
6505 68886
6505 68887
6505 68888
6505 68904
316 Remote Web Console for Storage System Messages and Error Codes
Error Message
The operation failed, because
the number of assignable
remote command device to a
mirror exceeded the
maximum.
The operation failed, because
a remote command device
was not assigned to the
specified mirror.
The operation failed, because
the specified volume was a
quorum disk.
The operation failed, because
the remote storage system did
not support the specified
operation.
The operation failed, because
the specified primary data
volume was as follows:
This volume was used as
T-VOL of FlashCopy
Mirroring V2.
This volume was used as
M-VOL of TrueCopy for
Mainframe, and it was
suspended by either of the
following settings:
It was a pair of
synchronous consistency
group.
It was a pair that the
Cylinder was set to
Difference Management.
The operation failed, because
the specified "primary data
volume" was used as T-VOL
of FlashCopy Mirroring V2
that might be in the abnormal
state due to a failure.
The operation of creating a
pair of the second mirror
failed because the specified
restore journal group was in
one of the following statuses:
It is a master journal
group of the first mirror.
It is a restore journal
group of the first mirror.
Recommended Action
Confirm the number of remote
command devices that has
been assigned to a mirror.
Check if a remote command
device was assigned to the
specified mirror.
Release the quorum disk, or
select another volume.
Confirm whether the remote
storage system supports the
specified operation.
Confirm the relationship
status of FlashCopy Mirroring
V2 and the pair status of
TrueCopy for Mainframe.
Confirm the relationship
status of the FlashCopy
Mirroring V2.
Verify the restore journal
group specified for the
second mirror.
Severity Failure
Level Level
W 0
W 0
W 0
W 0
W 0
W 0
W 5