HP XP20000/XP24000 Manual page 397

Table 67 Error Codes — Part Code 8105 (continued)
Part Error Error Message
Code Number
8105 101 1 An error occurred. If this
problem persists, call HP
technical support.
8105 1012 LU path is set to a volume
which links as an expanded
LU.
8105 1013 The emulation types of the
volumes combined into a
LUSE volume are not the
same.
8105 1015 LU path is set to the releasing
expanded LU. (You need to
release the expanded LU and
path at the same time.)
8105 1018 An error occurred. If this
problem persists, call HP
technical support.
8105 1022 An error occurred. If this
problem persists, call HP
technical support.
8105 1023 The specified fiber address is
wrong.
Recommended Action
The volume which links as an
expanded LU extend over
CU#. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The emulation type of a
volume which links as an
expanded LU is not the same.
The error does not occur
normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
The configuration information
has been already changed.
Check the settings, and
request the setting of the
configuration information
again.
The specified port does not
exist. You have specified a
wrong port number. Or the
specified port type
(exclusively for mainframe)
cannot be processed in this
agent. The error does not
occur normally because it is
guarded in the screen. In the
unlikely event that this error
occurs, contact HP technical
support.
Host mode is invalid. (The
specified value is not in the
specification.) The error does
not occur normally because
it is guarded in the screen. In
the unlikely event that this
error occurs, contact HP
technical support.
Correct the specified content,
and issue the request again.
(Currently, Bad Value Send
report in Set Response.)
Remote Web Console Error Codes 397
Severity Failure
Level Level
E 2
E 6
E 2
E 6
E 2
E 2
W 5