HP XP20000/XP24000 Manual page 266

Table 54 Error Codes — Part Code 6505 (continued)
Part Error
Code Number
6505 71 1 1
6505 7310
6505 8000
6505 8001
6505 8002
6505 8100
6505 8102
6505 8700
6505 8701
6505 8702
6505 8703
6505 8704
6505 8705
266 Remote Web Console for Storage System Messages and Error Codes
Error Message
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
This error code is not
registered.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
A communication time-out
error occurred in the
subsystem. Wait for a while,
and then retry the operation.
A communication time-out
error occurred in the
subsystem. Wait for a while,
and then retry the operation.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
This function is not supported.
Retry operation.
The logical path between the
local and the remote
subsystems is invalid.
The status of the primary data
volume is not valid.
The specified number of
paths is less than the
minimum number of paths in
the DKC Option window.
The specified number of
paths is less than the
minimum number of paths in
the DKC Option window, due
to a communication error
between the local and the
remote subsystems.
The path could not be deleted
due to a communication error
between the local and the
remote subsystems.
Recommended Action
If the error occurs after
retrying, call HP technical
support.
If the error occurs after
retrying, call HP technical
support.
Retry the operation. If this
problem persists, call HP
technical support.
Wait a few seconds, and
then retry the operation.
Wait a few seconds, and
then retry the operation.
Retry the operation. If this
problem persists, call HP
technical support.
Check whether the
DKCMAIN microcode version
and the SVP microcode
version are mismatched.
Retry the operation.
Check the path status and
edit the path again.
Refresh and check the
window. If possible, retry the
operation on the primary
data volume.
Check the number of paths.
Check the path status in the
DKC Status window, and
then restore the paths.
Check the CHA status on the
window. If the CHA is
blocked, replace the CHA,
and then retry the operation.
Severity Failure
Level Level
E 2
E 5
E 3
E 3
E 3
E 2
E 3
i 4
i 4
i 4
i 4
W 4
W 4