HP XP20000/XP24000 Manual page 186

Table 42 Error Codes — Part Code 4105 (continued)
Part Error
Code Number
4105 7060
4105 71 1 1
4105 7310
4105 7441
4105 8001
4105 8002
4105 8102
4105 8659
4105 56524
4105 56525
4105 56526
4105 57007
4105 57008
4105 57009
186 Remote Web Console for Storage System Messages and Error Codes
Error Message
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
An error occurred during
server processing. If this
problem persists, call HP
technical support.
Unregistered error code.
The value you have set
exceeds the available cache
size.
A communication time-out
error occurred.
Communication busy. Retry
later.
The SVP version and the DKC
version do not match.
No PCBs are installed.
This function cannot be used
by the storage partition
administrator.
Because the settings across
the multiple SLPRs are
contained, the authority has
been shifted to the storage
administrator from the
storage partition
administrator. To continue the
operation, contact the
storage administrator. To
perform other operations,
select a function button.
The resources of other SLPR(s)
cannot be accessed.
The sum of the maximum
values of the PCR capacity
per CLPR does not match the
maximum value of total PCR
capacity.
The maximum value of PCR
capacity per the specified
CLPR is not multiples of
512MB.
The capacity of PCR that
each CLPR uses exceeds the
maximum value of PCR
capacity per CLPR.
Recommended Action
If this problem persists, call
HP technical support.
An error occurred during SVP
processing. If this problem
persists, call HP technical
support.
If this problem persists, call
HP technical support.
Correct the specified content,
and issue the request again.
Retry the operation. If you get
the same message again,
reboot the computer. If
necessary, call HP technical
support.
Wait a few seconds, and
then retry the operation.
Call HP technical support.
Install PCBs.
Select another window. To
set this function, contact the
storage administrator.
To continue the operation,
contact the storage
administrator and have the
settings across the multiple
SLPRs cancelled, and then
retry the operation.
To perform other operations,
click a function button.
Correct the settings, and then
retry the operation.
Check the settings, and retry
the operation.
Check the settings, and retry
the operation.
Check the settings, and retry
the operation.
Severity Failure
Level Level
E 2
E 3
E 5
E 3
E 3
E 6
E 2
E 5
E 3
E 3
E 6
E 6
E 6
E 6