System Services Settings - HP Surestore 6164 - Switch Reference Manual

System Services Settings

Telnet Commands
There are two fields that are used to specify the system service settings.
Table 1. System Service Settings
Field
rstatd
rusersd
This section provides a description of the system service setting fields:
rstatd Dynamically enables or disables a server that returns
information about system operation information
through remote procedure calls (RPC). The protocol
provides for a wide-range of system statistics; however,
only Ethernet interface statistics (see
system up time (see
The retrieval of this information is supported by a
number of operating systems that support RPC. On
most UNIX-based systems (HP-UX, Irix, Linux, etc.),
the commands to retrieve the information are
rsysinfo
the appropriate usage of these or equivalent commands.
rusersd Dynamically enables or disables a server that returns
information about the user logged into the system
through remote procedure calls (RPC). The information
returned includes user login name, the system name,
login protocol or type, login time, idle time, and remote
login location (if applicable).
The retrieval of this information is supported by a
number of operating systems support RPC. On most
UNIX-based systems (HP-UX, Irix, Linux, etc.), the
command to retrieve the information is
your local system documentation for the appropriate
usage of this or an equivalent command.
Type Default
Boolean Off
Boolean Off
) are supported.
uptime
. See your local system documentation for
Range
On/Off
On/Off
) and
ifShow
and
rup
. See
rusers
45