HP Surestore 6164 - Switch Reference Manual page 63

Operands
Telnet Commands
It can also be looped by specifying the
enables you to specify a repeat interval for this command. If a repeat
interval is specified, the command continues to execute until interrupted.
For example,
diagShow 4
stopped by a keyboard interrupt.
Also use this command to isolate a bad GBIC. A changing "
value prefixed by "**" indicates a port is continuing to detect errors.
This command has the following operand:
Specify the repeat interval (in seconds) between
nSeconds
executions of
specified, the command continues to execute until
interrupted. If this operand is not used, the default is to
print the information once. Valid values are from 1 to
2**32. This operand is optional.
nseconds
executes
diagShow
. If a repeat interval is
diagShow
operand. This operand
every 4 seconds unless
LLI_errs
"
63