Ipaddrset - HP Surestore 6164 - Switch Reference Manual

ipAddrSet

Synopsis
Availability
Description
Operands
Telnet Commands
Set Ethernet and FC IP addresses.
ipAddrSet
admin
Use this command to set Ethernet and FC IP addresses. You are prompted
for address end mask information:
• Ethernet IP Address: IP address of the Ethernet port
• Ethernet Subnetmask: IP subnet mask of the ethernet port
• Fibre Channel IP Address: IP address of the fibre channel ports
• Fibre Channel Subnetmask: IP subnet mask of the fibre channel ports
• Gateway Address: IP address of the gateway
After each prompt, the current value is shown. You can respond in several
ways:
• Press to retain the current value.
return
• Enter an IP address in conventional dot ('.') notation.
• Enter .
none
• Press
control-C
• Press
control-D
The final prompt allows you to set the new IP addresses immediately. Enter
to set new addresses immediately; enter
y
next switch reboot. (Entering
A change to these values issues a Domain Address format RSCN (see
FC-FLA for a description of RSCNs).
None.
to cancel changes.
to accept changes and end input.
closes the telnet session.)
y
to delay the changes until the
n
105