HP Surestore 6164 - Switch Reference Manual page 264

Table 18. Diagnostic Error Messages (continued)
Message
DIAG-MEMSZ
Err#0111
[ramTest]
DIAG-MEMORY
Err#0110
[ramTest]
DIAG-NOSEGMENT
Err#3081,3881
[crossPortTest,
spinSilk]
DIAG-PORTABSENT
Err#2670, 3070, 3870
[portLoopbackTest,
crossPortTest, spinSilk]
DIAG-PORTDIED
Err#265F, 305F, 385F
[portLoopbackTest,
crossPortTest, spinSilk]
DIAG-PORTM2M
Err#3080, 3880
[crossPortTest,
spinSilk]
264
Description
Memory size to be tested is less
than or equal to zero
Data read from RAM location did
not match previously written data
into same location
Port failed to go into loopback
mode
Port is not present
Port was in loopback mode and
then went inactive
Port is found to be connected to
itself (self loopback). This Port M
to Port M connection is not
allowed by the test
Probable Cause Action
mainboard Replace
failure mainboard
assembly
CPU RAM Replace
failure mainboard
assembly or
DRAM module
Improper GGIC Reseat GBICs and
or cable cables and
connection re-execute test
ASIC or Replace
mainboard mainboard
failure assembly
ASIC, GBIC Replace
module, or fibre mainboard
cable failure assembly, GBIC
module, or fibre
cable
Improper cable Reconnect port
connection (M) to another port
(N) and re-execute
test
Fabric OS Reference Manual