HP Surestore 6164 - Switch Reference Manual page 165

Telnet Commands
Table 11. PortLogShow fields (continued)
Field Description
args The command arguments – description depends on event type:
star
disable
enable
ioctl
&
Tx Rx
reject
busy
ctin
ctout
errlog
start type: = enable ports,
0
state (see codes)
state
mode: = normal, non-zero = loopback
0
I/O control arguments
first two header words and first payload word
FC-PH reject reason
FC-PH busy reason
Argument 0 is divided into two 16-bit fields:
[A] bit map indicating validity of subsequent args
( = argument 1 is valid,
0001
= arguments 1 and 2 are valid)
0003
[B] ct-based service command code
Argument 1 = first word of the CT payload, if
applicable (as specified in [A])
Argument 2 = second word of the CT payload,
if applicable (as specified in [A])
Argument 0 is divided into two 16-bit fields:
[A] bit map indicating validity of subsequent args
( = argument 1 is valid,
0001
= arguments 1 and 2 are valid)
0003
[B] CT command code indicating an accept (
or a reject (
8001
If [B] is an accept, arguments 1 and 2 represent
the first and second words of the CT payload, if
applicable (as specified in [A]).
If [B] is a reject, argument 1 contains the CT
reject reason and explanation code.
error type (see
errShow
being created
= disable ports
100
)
) create - name of the task
)
8002
165