Kyocera TASKalfa 250ci Operation Manual page 354

Default Setting (System Menu)
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6):
Off. Use the procedure below.
Manual Setting (IPv6)
Manually specify the IP address, prefix length, and gateway address of TCP/IP (IPv6). The manual setting is
available when selecting [On] for TCP/IP (IPv6). Use the procedure below.
8-90
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3
Press [Change] of TCP/IP.
4
Press [On] and then press [OK].
5
Press [Next] of IPv6.
6
Press [Change] of IPv6.
7
Press [On]. IP Address (Link Local) appears.
8
Press [OK].
9
After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3
Press [Next] of IPv6.
4
Press [Next] of Manual Setting.
5
Press [IP Address (Manual)] to enter IP address.
The format of the IPv6 address is a sequence of
numbers (128 bit in total) separated by colons, e.g.
2001:db8:3c4d:15::1a2c:1a1f.
6
Press [OK].
Press [# Keys] of Prefix Length (0 - 128) to enter
the prefix length using the numeric keys.
7
Press [Default Gateway] to enter the default
gateway.
8
Check that all the entries are correct and Press
[OK].
OPERATION GUIDE