Replacing A Removable Media Drive; Removing And Replacing The Mp Card - HP Integrity rx2620 User's & Service Manual

2. Remove the top metal cover. See
(page 33).
3. Disconnect the IDE cable from the back of the drive. See
4. Grasp the front of the DVD drive and squeeze in on the locking tab to release
the drive.
5. Pull the drive straight out to remove it from the chassis.
Figure 59 Removing and Replacing Removable Media Drive

Replacing a Removable Media Drive

To replace the removable DVD drive:
1. If a removable media drive has not previously been installed in the server, the
drive slot is covered with a DVD drive blank. Remove the DVD drive blank.
2. Slide the replacement drive into the drive bay until it stops, and the retaining clips
on both sides snap into place.
3. Connect the IDE cable to the back of the drive.
4. Replace the top metal cover.
5. Reconnect the power and external cables and power on the server.
6. Verify the drive replacement by using the utilities identified in
(page 134).
Load removable media and access to verify operation.
To verify operation, use the iLO MP commands.
Use diagnostics provided by the ODE to exercise the module replaced.

Removing and Replacing the MP Card

The MP card is the hardware that provides a way to connect to a server and perform
administration or monitoring tasks for the server. The iLO is the firmware that provides
the way for the MP to communicate as an independent support system for the server.
"Removing and Replacing the Top Metal Cover"
Figure 59.
Appendix C
66