Table of Contents
Advertisement
Protocol: <INACT>
IGMP Interface Configuration
This menu allows the configuration of IGMP for each IP
interface configured on the switch. IGMP can be configured
as Version 1 or 2 by toggling the Ver:<2> field. The length
of time between queries can be varied by entering a value
between 1 and 65,500 seconds in the Query:[125 ] field.
The maximum length of time between the receipt of a query
and the sending of an IGMP response report can be varied
by entering a value in the Max. Response:[10] field.
56 VH-2402-L3 Management Guide
bar. This will enable or disable IGMP for
the IP interface entered above.
This field can be toggled between
Protocol Independent Multicasting –
Dense Mode (PIMDM), Distance Vector
Multicasting Routing Protocol
(DVMRP), and INACT (inactive). INACT
is not a multicast routing protocol. It is
used to make a given interface inactive
for IP Multicast routing yet can still route
IP traffic.
Figure 1-42. IGMP Interface Configuration
9033691-01
Advertisement
Table of Contents
