Accumulator assembly (stapler/stacker only)
1
2
Figure 108.
Accumulator assembly (1 of 3)
3
Note
Removal of the carriage assembly is not required, but removing it makes removing and reinstalling
the accumulator very easy. See "Carriage assembly (stapler/stacker only)" on page 144.
ENWW
Remove the following FRUs:
• Face-up bin. See page 129.
• Stapler/stacker bin. See page 129.
• Back inner cover. See page 130.
• Front inner cover. See page 130.
• Front cover. See page 131.
• Back cover. See page 132.
• Controller PCA cover. See page 135.
• Accumulator wings. See page 139.
• Paper-stop clips. See page 140.
Unplug the ribbon cable (callout 1) from the controller PCA by pressing the black tabs on the
cable connector.
2 1
Push the ribbon cable up through the hole.
Chapter 6 Removal and replacement 141