5
Figure 110.
Accumulator assembly (3 of 3)
Note
Make sure that you remove the accumulator wings and the paper-stop clips before proceeding to
step 6.
6
7
To reinstall
Note
To prevent ribbon or staple-cartridge damage, make sure that you correctly install the ribbon
retention wire.
CAUTION
Do not reinstall the paper-stop clips before you reinstall the accumulator. Reinstalling the
accumulator with the clips in place can break the clips.
ENWW
Use a Torx #20 screwdriver to remove four mount screws (callout 3).
Grasp the accumulator assembly on each side and lift up to clear the tabs.
Remove the accumulator assembly.
2 3
Chapter 6 Removal and replacement 143