4
Note
You can use needle-nose pliers or your fingers to unplug the ground wire.
Figure 144.
Flipper assembly (3 of 7)
5
Note
You must remove the retaining tubes in order to remove the cable connectors.
Figure 145.
Flipper assembly (4 of 7)
ENWW
On the left side of the 8-bin mailbox, hold down the jam-access handle (callout 3) while
unplugging the ground wire (callout 4) that connects the input paper guide to the flipper
motor.
3
On the back of the 8-bin mailbox, disconnect three cable connectors (callout 5).
4
5
Chapter 6 Removal and replacement 171