Cable assembly
1
2
3
4
5
Figure 127.
Cable assembly
158 Removal and replacement
Remove the following FRUs:
• Face-up bin. See page 129.
• Stapler/stacker bin. See page 129.
• Back inner cover. See page 130.
• Back cover. See page 132.
• Controller PCA cover. See page 135.
Disconnect the ribbon cables from the flipper assembly, the path assembly, and the
controller PCA.
Disconnect the power cable from the power supply.
Loosen two screws, and then disconnect the Jet-Link cable from the controller PCA.
Use a Torx #20 screwdriver to loosen one screw (callout 1), and remove three screws
(callout 2), and then lift the cable assembly away from the output device.
1
2
2
2
ENWW