4
5
Figure 100.
Back cover (2 of 2)
6
To reinstall
CAUTION
To prevent damage, make sure that the three locking tabs (not shown) are locked into the output
device frame before you reinstall the screws. Install the long screws in the top holes on the back
cover.
ENWW
Use a Torx #20 screwdriver to remove three screws (callout 2).
Press and hold the interlock switch (callout 3) while lifting the cover upward until the cover
releases from the output device.
2
2
Guide both cables out of the cavity.
3
2
Chapter 6 Removal and replacement 133