Wind On Bobbin Thread - Duerkopp Adler 530 Operating Instructions Manual

7.5 Wind on bobbin thread

5
4
3
12
1
2
–
Put bobbin on bobbin winder 4.
–
Pull thread through guide 2 and around tension 1.
–
Wind thread counter-clockwise around the core of the bobbin
(approx. 5 times).
–
Press winder lever 3 into the bobbin.
–
Sewing
The winder lever stops as soon as the bobbin is full.
–
Tear off thread at thread clamp 5 after winding on is finished.
Note !
If the thread is to be wound on without sewing,
the thread winding mode can be altered in submenu 6 "Special
functions".
If the thread winding mode is active, the sewing motor can be started
via pedal or push button independent of the sewing field drive (here
unthread at the thread lever).
For adjustment see chapter 8.5.1 "Thread winding mode".
6
On
Off