Duerkopp Adler 530 Operating Instructions Manual page 67

Create contour
In this menu the X- and Y-coordinates are entered for every individual
stitch.
Note:
In order to enter stitch operations (f. e. intermediate trimming), first
finish the contour creating (entering of coordinates) and then insert the
stitch operation in the menu change contour by editing.
X1:
Input of the X-coordinate for stitch 1
Input: -20.0 ... +20.0
Y1:
Input of the Y-coordinate for stitch 1
Input: -10.0 ...+10.0
Note:
The value X1 can be altered according to chapter 8.3.1.
Select the menu item Y1 with key "ò" after confirmation of the value
for X1 with key "OK".
The values for Y1, X2, Y2, X3 and Y3 can be altered as described for
the value X1.
Select menu item "Add stitch" with key "ò" after confirmation of the
input of Y3 with key "OK".
After selection of this line with key "OK" the next coordinates Xn+1 and
Yn+1 (here: X4 and Y4) are given in the two upper menu lines. The
selection bar changes to the line Xn+1 (here: X4) automatically. The
values Xn+1 and Yn+1 can be altered as described above when
required. This procedure can be repeated until the stitch coordinates
are completely entered.
When the input of coordinates is finished, the line "Exit" has to be
selected in the submenu "Parameter/End". Then the menu "Free
contours" appears again.
Append stitch
Function for appending a stitch.
The coordinates for the first three stitches (here: X1/Y1, X2/Y2 and
X3/Y3) are shifted upwards and the display shows Xn+1/Yn+1 (here:
X4/Y4).
append stitch
parameter/end
65
1