Duerkopp Adler 530 Operating Instructions Manual page 68

66
Submenu parameter
Selection of the submenu for entering the contour parameters
Abst. X:
Abst. Y:
Standard rpm:
Standard speed
Input: 100 ... 2700 rpm
Distance X:
Hole distance in X-direction
Input: 0 ... 40.0 mm
Distance Y:
Hole distance in Y-direction
Input: 0 ... 20.0 mm
Preset value = outer stitches in X- and Y- direction
The value must be changed to match the hole distance of the button
(as regard to the correct scaling in the main menu).
If the free seam contour from the main screen is selected
and one of the distance X/Y or both is changed, the value of
the length or the width must be changed correspondingly
in the main menu.
std. rpm
dist. x
3.4
dist. y
3.4