Removing The Paper Eject Sub-Roller Unit; Removing The Paper Eject Roller Unit - Brother LX-200 Service Manual

3.10.2

Removing the Paper Eject Sub-roller Unit

1. Remove the paper eject shaft holders L/R attached to the paper eject sub-roller unit
by pulling them from the paper eject roller shaft in the direction of the arrow.
2. Remove the paper eject shaft holders L/R from the removed paper eject sub-roller
unit.
3.10.3

Removing the Paper Eject Roller Unit

1. Pull out the Y-gear 40-16 from the shaft and remove the gear 20. Take care not to
damage the gear hook by opening too far while removing the Y-gear 40-16.
2. Remove the gear 16 hook from the paper eject roller unit. Take care not to damage
the gear hook by opening too far.
3. Turn the paper eject roller bearing L clockwise at the chassis left side with needle-
nosed pliers and remove it. Remove the paper eject roller screw then turn the paper
eject roller bearing R counterclockwise at the chassis right side with needle-nosed
pliers and remove it.
Gear 40-16 hook
Paper eject roller unit
Paper eject sub-roller unit
Paper eject shaft holders L/R
Fig. 3.10-3 Removing the Paper Eject Sub-roller Unit
Gear 16 hook
Paper eject roller Bearing
Gear 20
Paper eject roller bearing
Fig. 3.10-4 Removing the Paper Eject Roller Unit (1)
3-29
Paper eject roller unit
Paper eject roller screw