Brother LX-200 Service Manual page 78

2. Insert the Y-D shaft (with cams) first into chassis R, then into chassis L. The Y-D
shaft should be inserted behind the paper eject shaft holders L/R.
3. Put the Y-driving gear onto the right semicircular end of the Y-D shaft. Next put the
Y-gear 40-20 on this shaft and push the gear until the hook engages.
4. Attach the left and right Y-extension springs (L/R). Attach the Y-extension spring L
(the longer one) to the LF motor mounting screw.
5. Attach the left and right paper eject sub-roller springs.
Fig. 4.9-5
Paper eject
shaft holder L
Y-D shaft
LF motor mounting
screw
Y-extension spring L
Y-cutter cam L/R
Paper eject sub-roller springs
Installing the Y-driving Shaft (2)
Y-driving gear
Paper eject
shaft holder
R
Y-extension spring R
4-16
Y-gear 40-20