Disassembling The Y-Cutter Arm L - Brother LX-200 Service Manual

3.8.4

Disassembling the Y-cutter Arm L

1. Remove the sensor holder screw. Remove the photosensor (PS) PCB holder from
the Y-cutter arm L.
2. Disengage the PS PCB holder hook. Turn the PL detect lever to a position where it
does not engage with the sensor, then remove it.
3. Remove the Y-CA sensor screw and remove the Y-CA sensor.
Y-CA sensor
Y-CA sensor screw
Sensor holder screw
Hook
Y-cutter arm L
Fig. 3.8-4 Disassembling the Y-cutter Arm L
3-25
Photosensor (PS) PCB holder
PL detect lever