Left Side Of The Chassis; Reassembling The Left Side Of The Chassis; Installing The Gears - Brother LX-200 Service Manual

4.5 Left Side of the Chassis

4.5.1 Reassembling the Left Side of the Chassis

1. Fasten the LF motor with one TC/LF motor screw and one LF motor screw.
2. Incline the roller guide L. Insert the cut-out into chassis L and push it into place until
the hooks engage in the boss hole.
TC/LF motor screw

4.5.2 Installing the Gears

Install the gears at the left side of the chassis in the sequence described below.
If the gear (or holder) has one or two hooks, push it into place until the hooks engage in
the locking groove in the shaft.
Gear 20, installed at step 3, is fastened by a ring.
1. Gear 50
2. Gear 20
3. Gear 20
4. Gear 20
5. Gear 48/24 (48-tooth side against chassis)
6. Gear 16M1
7. Gear 60/16 (16-tooth side against chassis)
8. Gear 60/16M1 (16-tooth side against chassis)
9. Gear 60/20 hook
10. Gear 20
11. Gear 21
12. Gear 40/16 hook
Roller guide L
LF motor screw
Fig. 4.5-1 Reassembling the Left Side of the Chassis
4-6
Boss hole
LF motor