Installing The Pe Sensor Unit - Brother LX-200 Service Manual

3.Remove the sensor frame screw from the sensor frame. Attach the ground wire and
fasten it with the sensor frame screw.

4.16.2 Installing the PE Sensor Unit

1.Engage the tip of the PE sensor unit with the paper sensor crank. Attach the PE
sensor unit to the paper feed roller, such that the sensor is located vertically above
the paper sensor crank. Take care not to damage the tip of the PE sensor unit
during installation.
2.Open the bottom cover bearing supports outward and mount the PE sensor unit in the
bearing supports.
PE sensor unit
Ground wire
Fig. 4.16-3 Installing the Chassis Unit (3)
PE sensor unit
Paper sensor crank
Fig. 4.16-4 Installing the PE Sensor Unit
4-32
Sensor frame
Sensor frame screw
Paper feed roller
Paper sensor crank
Bearing supports