3.13 Driving Roller Shaft
3.13.1
Removing the Driving Roller Shaft
1. Remove the driving roller C ring. Remove the gear 16M1 hook and driving roller
bearing. Take care not to open the driving roller C ring too far.
2. Remove the driving roller E ring. Remove the driving roller bearing.
3. Remove the driving roller shaft.
Driving roller C ring
Gear 16M1 hook
Bearing
3.14 Left Side of the Chassis
3.14.1
Removing the Gears
Remove the gears from the left side of the chassis in the sequence described below.
If the gear has one or two hooks, disengage the hooks from the locking groove in the
shaft before removing. Gear 20, removed at step 18 is fastened by a ring. Remove the
ring before removing the gear.
1. Gear 37 hook
2. TY-planet gear unit
Remove the TY-planet gear holder, before removing the felt, TY-idle gear, and TY-
spring washer from the shaft. Remove the TY-planet gear from the TY-planet gear
holder.
3. Gear 25 hook
4. Planet 20 hook (two)
Remove the planet 20 hook, before removing the felt, TY-planet gear holder, TY-spring
washer, and TY-planet gear.
Driving roller shaft
Fig. 3.13-1
Removing the Driving Roller
3-33
Driving roller E ring
Bearing