Adjusting The Left Y-Cutting Position - Brother LX-200 Service Manual

6.3.2

Adjusting the Left Y-cutting Position

Loosen the screw and move the photosensor (PS) PCB holder left or right. This moves
the detection position of the sensor attached to the photosensor (PS) PCB holder and
adjusts the cutting position for the left edge of the sheet.
In the diagram below, move the photosensor (PS) PCB holder to the right to increase
the border of the laminated document.
Screw
Photosensor (PS) PCB holder
Y-cutter arm L
Fig. 6.3-2 Adjusting the Left Y-cutting Position
6-18