Installing The Roller Holder Assy - Brother LX-200 Service Manual

4.12.2 Installing the Roller Holder Assy

1. Move the Y-cutter arm L as far as possible to the left.
2. Insert the chassis unit R boss shaft into the hole in the roller holder assy, then insert
the chassis unit L boss shaft. Attach the roller holder rings to the left and right boss
shafts to fasten the roller holder assy in position.
3. Lift up the roller holder assy and attach the roller holder spring.
Roller holder assy
Y-cutter arm L
Chassis unit L
boss shaft
Roller holder rings
Fig. 4.12-2 Installing the Roller Holder Assy
4-24
Chassis unit R boss shaft
Roller holder spring