Brother LX-200 Service Manual page 85

7. Put the interference board, set button L, and lock lever spring L onto the lock lever
shaft. Pass the shaft through the hole in the left side of the roller holder assy.
8. Insert the lock lever shaft in the semicircular hole in lock lever R. Insert hook B of
lock lever L from the position of cut-out A as with lock lever R, and turn to fasten in
position.
9. Fasten the lock lever springs L/R inside the lock levers L/R.
10. Fasten the left and right side covers L/R to the roller holder by engaging the
individual two hooks A to it.
Hooks A
Side cover L
Release plate L
Press roller
spring L
Boss hole
Release plate
ring
Set button L
Tape hold
Sub-roller bearing L
bearing L
Tape hold shaft
Lock
Hook B
lever L
Cut-out A
Lock lever
spring L
Lock lever
Extension
shaft
spring 0.4
Interference
board
Sub-roller assembly
Tape hold bearing R
Sub-roller bearing R
Fig. 4-12-1 Reassembling the Roller Holder Assy
4-23
Lock lever R
Roller holder
Set button R
Roller holder
E Lock lever spring R
Cut-out A
Lock lever
spring R
Set button
Extension
R
spring 0.4
Boss hole
Release plate R
Part B
Lock lever R
Hook C
Hook A
Side
cover R
Hook A
Press roller spring R
Release plate ring