AT&T MERLIN Attendant for MERLIN LEGEND Installer's Manual page 59

Testing and Troubleshooting
1. Dial the MERLIN Attendant extension from a Touch-Tone phone,
preferably a single-line set.
2. Wait for an answer.
3. Dial
*
4. Dial
*
01 = Day Answer Delay
02 =
03 = Dialing Delay
5. Dial .
#
6. Once the report is completed, exit authorized caller mode by dialing
.
#
*
7. To disconnect, dial .
Lost Authorized Caller Code
If the default authorized caller code (789) is changed and the new code is lost
or forgotten, the default code can be restored. However this procedure also
restores all the MERLIN LEGEND factory settings so that any changed
programmed setting must be re-entered and all announcements must be
re-recorded.
To restore the factory setting authorized caller code:
1. On the back of the MERLIN Attendant, set switches 1 and 2 to off (up).
2. Unplug the MERLIN Attendant from its power source.
3. With switches 1 and 2 still off (up), plug the MERLIN Attendant back into
its power source.
4. Reset switches 1 and 2 to on (down).
5. Use the appropriate MERLIN Attendant Planning Forms to reprogram
your settings and rerecord your announcements.
followed immediately by the authorized caller code and
followed by the appropriate selection:
2 9
Answer Delay
Night
#
#
Troubleshooting
.
3-9