Table of Contents
Advertisement
Installation and MERLIN LEGEND System Programming
7. Make sure setup switches 1 and 2 are off, then plug one end of the
modular phone cord into the jack on the back of the MERLIN Attendant
labeled "to line." (See Figure 1-3.)
Figure 1-3
8.
Plug the other end of the modular phone cord into an programmed
MERLIN Attendant port on the Basic Telephone (012) Module. (See
Figure 1-4.)
9.
Plug one end of the power cord into the 10 VAC power connector on the
MERLIN Attendant.
10. Plug the other end into a 120 VAC outlet.
The power light goes on. If the battery light flashes, one or more
prompts have not been programmed.
11. Reset the setup switches as described in Table 1-6.
Setup Switch Positions for Installing Unit
Connecting the MERLIN Attendant
1-19
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the MERLIN Attendant for MERLIN LEGEND and is the answer not in the manual?
Questions and answers