Printing Reports; Setting The Baud Rate - AT&T MERLIN Attendant for MERLIN LEGEND Installer's Manual

Testing and Troubleshooting

Printing Reports

You can connect a TI 700 or equivalent 1200-baud serial printer to the serial
i/o port of the MERLIN Attendant to produce reports to analyze call traffic
patterns or to see how routes, announcement times, or business schedules
are programmed.
NOTE:
A special adapter is required to connect a "silent 700" printer.

Setting the Baud Rate

The default baud rate for the serial i/o port is 9600. To connect the printer, set
the baud rate to 1200 using the following procedure:
1. Dial the MERLIN Attendant extension from a Touch-Tone phone,
preferably a single-line set.
NOTE:
If you are programming from a multiline Touch-Tone phone connected
to a MERLIN LEGEND system control unit, you must enter an additional
each time a
#
2. Wait for an answer.
3. Dial followed immediately by the authorized caller code and
*
The two-beep confirmation tone sounds.
4. Dial
*
The two-beep confirmation tone sounds.
5. Continue programming or exit authorized caller mode by dialing
6. To disconnect, dial
appears in a programming command.
#
to change the baud rate to 1200 baud.
2 9 1 7 1 2 #
.
#
#
*
Troubleshooting
.
.
#
3-5