AT&T MERLIN Attendant for MERLIN LEGEND Installer's Manual page 58

Testing and Troubleshooting
4. Dial
*
1
2 = print traffic analysis report
3 = print business schedule
4 = print announcement time allocations
5. Once the report is complete, exit authorized caller mode by dialing
6. To disconnect, dial
Resetting the Counters
To reset the call handling traffic statistics to 0, perform the following steps:
1. Dial the MERLIN Attendant extension from a Touch-Tone phone,
preferably a single-line set.
NOTE:
If you are programming from a multiline Touch-Tone phone connected
to a MERLIN LEGEND system control unit, you must enter an additional
each time a appears in a programming command.
#
2. Wait for an answer.
3. Dial followed immediately by the authorized caller code and .
*
4. Dial
*
5. Exit authorized caller mode by dialing
6. To disconnect, dial .
Printing Call Processing Reports
To print the current settings of call processing options, perform the following
steps:
3-8
Troubleshooting
and the following appropriate choice:
2 9 0 9
= print route programming
.
#
#
.
2 9 1 0 1
#
.
#
*
.
#
*
#