Disabling Power To The Crs-1 Fabric Card - Cisco CRS-1 - Carrier Routing System Router Migration Manual

Carrier routing system
Hide thumbs Also See for CRS-1 - Carrier Routing System Router:
Table of Contents

Advertisement

How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot)
DETAILED STEPS
Command or Action
Step 1
admin
Example:
RP/0/RP0/CPU0:router#admin
Step 2
configure
Example:
RP/0/RP1/CPU0:router(admin)#configure
Step 3
controller fabric plane 0 shut
Example:
RP/0/RP1/CPU0:router(admin-config)# controller
fabric plane 0 shut
Step 4
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Step 5
end
Example:
RP/0/RP1/CPU0:router(admin-config)# end
Step 6
Repeat Step 3 through Step 5 for each fabric plane.
Step 7
show controllers fabric plane all
Example:
RP/0/RP1/CPU0:router(admin)# show controllers
fabric plane all
What to Do Next
Next we disable power to the Fabric node, and verify that node is moved to Unpowered state.

Disabling Power to the CRS-1 Fabric Card

Prerequisites
Software Requirements
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-60
Cisco IOS XR Software Release 4.0.0.T or later release (Cisco IOS XR Software Release 4.0.2 for
multishelf nodes)
ROMMON 1.54 or later version (for Route Processor [RP])
Chapter 1
Migrating to a Cisco CRS-3 Carrier Routing System
Purpose
Places the router in administration EXEC mode.
All commands listed in this procedure should be
entered on the pre-existing single-chassis system.
Places the router in administration configuration mode.
Shuts down the fabric plane in the system.
In a 4-slot CRS-1 router, we have four fabric nodes, or
Fabric Controller cards, numbered 0/SM0/SP to
0/SM3/SP. Each Fabric Controller card has one plane.
So for a 4-slot CRS-1 to CRS-3 migration we will be
migrating one plane at a time for all four planes.
Commits the target configuration to the router running
configuration.
This step brings up the previously shutdown plane,
which is now configured to use the CRS-3 fabric card.
Changes the mode from administration configuration mode
to administration EXEC mode.
Displays the administrative and operational status of all
eight fabric planes.
Verify that all fabric planes are administrative state
down.
OL-13669-03

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crs-3

Table of Contents